Navigate to the Proteus installation directory. Typically:
: Connect the sensor's digital outputs (DT and SCK) to a microcontroller like an Arduino Uno , which can be simulated directly in Proteus.
When setting up your simulation, follow this standard wiring for or 8051 microcontrollers: 📍 Pin Mapping VCC: Connect to 5V DC. GND: Connect to Ground. DT (Data): Connect to any Digital Pin (e.g., Arduino D3). SCK (Clock): Connect to any Digital Pin (e.g., Arduino D2). hx711 proteus library
void loop() long reading = scale.read(); Serial.println(reading); delay(500);
* HX711 Load Cell Amplifier Model for Proteus * Created for simulation purposes Navigate to the Proteus installation directory
* Internal logic simulation (Simplified) * This generates a pseudo-random 24-bit value based on simulation time * to simulate the weight reading.
To compile code for the simulation, write an Arduino sketch that uses the official Bogdan Necula HX711 Library . After writing the code in the Arduino IDE, export the compiled .hex file to upload into Proteus. GND: Connect to Ground
Testing Checklist (what to verify in simulation)