Arduino Sensor Shield V5 0 Manual Jun 2026

Plug and Play. Instead of using a breadboard and male-to-female jumpers for every sensor, you plug standard 3-pin sensors (Signal, VCC, GND) directly into the shield’s grouped ports.

The digital pins use the Arduino’s onboard 5V regulator. This is suitable for low-power sensors but may fail if driving multiple servos. arduino sensor shield v5 0 manual

For convenience – e.g., I2C appears both on A4/A5 and dedicated header. Plug and Play

is an expansion board designed to simplify the connection of multiple sensors, servos, and modules to an Arduino Uno or Mega. It eliminates the need for complex breadboard wiring by providing dedicated power, ground, and signal pins for every digital and analog I/O port. Key Connection Layout you plug standard 3-pin sensors (Signal