Never replace components or adjust the inside of test equipment while the high-voltage supply is on. Configuration: For newer IP-based systems (like
| Symptom | Likely Cause | Corrective Action | | :--- | :--- | :--- | | | Air in the hydraulic fluid | Bleed the system via the top port. Run 10 full cycles. | | No movement, but pressure is present | Broken spline coupling or stripped shaft | Inspect coupling. Replace shaft (requires full disassembly). | | Sluggish response | Contaminated pilot valve filter | Replace 5-micron filter. Flush the return line. | | External leakage at shaft | Worn primary seal | Perform DASS167 seal replacement (special tool #D167-PR required). | | Overheating (>85°C) | Incorrect viscosity or continuous stalling | Switch to ISO VG 32. Adjust the load limiter. | dass167 work
High-detail character designs and concept art. Never replace components or adjust the inside of