Chaser Ch-e80 Print Driver ((new))

Click "Install" and perform a Test Print to confirm the driver is communicating correctly. Key Features & Settings

| Symptom | Likely Cause | Solution | |---------|--------------|----------| | Prints gibberish | Wrong driver (e.g., Epson) | Remove and reinstall correct driver | | Skips labels | Sensor mode wrong | Set to “gap” in utility | | Cuts half receipt | Page size mismatch | Define custom paper size (80mm x 297mm) | | USB not detected | Power cycle order | Connect USB only after driver install | | Slow network printing | Windows RAW vs LPR | Use LPR with queue name “lp” | Chaser Ch-e80 Print Driver

No bidirectional status monitoring. If the printer runs out of paper, Windows will still show "Ready" until you try to print. Click "Install" and perform a Test Print to

Check the physical connection. Ensure the paper roll is inserted correctly (thermal side facing the print head). If the red "Error" light is blinking, it usually means the paper is out or the cover isn't latched. 2. Printing "Gibberish" Check the physical connection